Aurora IS007 Instruções de Operação

INSTALLATION & OPERATING INSTRUCTIONS SAI Global Approval No. GSCS20025 Australian Patent PN 200110001S Effective January 2009 Serial Number

INSTALLATION INSTRUCTIONS LOG INSTALLATION - MODEL IS 700 The gas log set (front log, middle log, rear log, left hand side log and right hand side) i

INSTALLATION INSTRUCTIONS 3. Remove all cardboard protection from inside the firebox and the two cross logs. Note: All other logs in the firebox h

INSTALLATION INSTRUCTIONS LOG SET DIAGRAM - IS700 1 2 3 4 5 6 7 11 The Gas Log Kit contains the following: 1) Rear Log 2) Middle Log

12 INSTALLATION INSTRUCTIONS FLUING REQUIREMENTS Co-Axial Flue Installations Note: This appliance has only been approved for co-axial flue applicati

For applications on Flexible Single Flue refer pages 16-17-18-19-20 SINGLE FLUE KIT FOR ARCHER GAS LOG SPACE HEATER No Description Qty 1 Single Flue

For applications refer page 15 and page 16 of this Installation Manual. 14 CO-AXIAL FLUE KIT FOR ARCHER GAS LOG SPACE HEATER Note: When connecting 40m

INSTALLATION INSTRUCTIONS Insert Model IS700 -With Co-Axial Flue - Exterior Masonary Fireplace Note: Do not use PVC cement to seal flue pipe connect

CREATED FIREPLACE MODEL IS100/IS200 Zero clearance, power flue, single 40mm flue and shallow unit depth allow you to create your own fireplace anywher

CAUTION: PLEASE DO NOT ALLOW WATER TRAPS TO FORM IN FLUE OR HEATER WILL CEASE TO OPERATE. Note: Total installation length in 40mm

INSTALLATION INSTRUCTIONS Internal Wall Under Floor Installation using 40mm ø PVC Flue. Note: All flue pipe connections need to be sealed with PVC c

1 TABLE OF CONTENTS SAFETY LABEL To The New Owner 2 Safety Labels 3-4 INSTALLATION INSTRUCTIONS Specifications 5

INSTALLATION INSTRUCTIONS Flexible Flue Kit to suit Fireplace Insert Installations Model IS700 STANDARD FLUE KIT SUPPLIED BY AURORA FOR INSERT INSTALL

INSTALLATION INSTRUCTIONS Fireplace Insert Installation Model IS100 -Using Aurora Flexible Flue Kit SFA002 with Single 40mm PVC Flue Pipe using 75mm c

OPTIONAL REMOTE CONTROL THERMOSTAT 21 Operator Switches Economy Display Mode Button Front Burner Rear Burner An optional programmable Remote Control

22 DISPLAY PANEL T2 T1 P2 RECEIVER REMOVE LINKS FROM T1, T2 AND P2 AND PLUG IN LOOM VIOLET INSTALL WIRING LOOMS LOOM BLACK CONNECT THIS W

INSTALLATION INSTRUCTIONS GAS CONNECTION (Line Supply) The gas connection is 1/2” BSP supplied in heater. GAS SUPPLY LINE TO HEATER a) Remove the

INSTALLATION INSTRUCTIONS GAS VALVE PRESSURE ADJUSTMENT The gas valve pressure adjustments must be checked during installation, and if necessary cor

ARCHER 2004 WIRING DIAGRAM 240V 50 Hz PIN 20 PIN 4 PIN 5 (3) WATER SENSOR WATER SENSOR (4) PUMP FAIL RED (2) (13) AIR.PR.SW.N.O. (15

INSTALLATION INSTRUCTIONS MAIN DOOR SAFETY SCREEN INSTALLATION 26 ! ANY SAFETY SCREEN OR GUARD REMOVED FOR SERVICING AN APPLIANCE MUST BE REPLACED PR

ASSEMBLY AND FITTING OF 3 AND 4 SIDED SURROUND FOR FLAT FRONT MODEL IS 700 IMPORTANT NOTE: When fitting the surround to the heater the main door and t

28 AUTOMATIC HUMIDIFIER OPERATION 1. The amount of condensate build up in the water sump is dependent on outside temperature, length and height of t

TO THE NEW OWNER Congratulations! You are the owner of a state of the art Archer High Efficiency Gas Log Space Heater. This appliance has been design

OPERATING INSTRUCTIONS CHECKLIST BEFORE OPERATING THIS APPLIANCE, CAREFULLY PROCEED THROUGH THE FOLLOWING CHECK LIST. 1. Read and understand these

OPERATING INSTRUCTIONS CHECKLIST cont... 11. Prior to operating the appliance check for dust or particles lying on top of the burners. Refer Pa

1. Main Electrical power supply must always be switched on to the unit with the two burner switches in the off position (up) before commencing ligh

32 The 3-speed main convection fan will cut in automatically approximately 3 to 5 minutes after the heater has warmed up. Note: The 3-speed main conv

33 OVER TEMPERATURE CUT OUT The Archer Gas Log Space Heater is protected against overheating with a high temperature 80° cut out switch to protect the

UNIT OPERATING FAULTS SERVICE AND INSTALLATION OF THE APPLIANCE SHOULD BE CARRIED OUT BY AUTHORISED PERSONNEL ONLY. THE MAJOR CAUSE OF OPERATING PROBL

MAINTENANCE Note: Your appliance should be inspected, serviced and checked annually by a qualified service person to ensure that your appliance

36 GLASS CLEANING After some period of operating time, due to normal condensation build up, which occurs every time the heater is lit, some water mark

COMPLETE UNIT WARRANTY DESCRIPTION WARRANTY PERIOD (FROM DATE OF PURCHASE) Heat Exchanger 5 Years Parts/1 Year Labour Main Convection Fa

38 CONDITIONS, EXCLUSIONS AND QUALIFICATIONS cont... 6. Aurora further assumes no liability for defects or damage caused by incorrect operating or pe

PLEASE KEEP THESE INSTRUCTIONS FOR FUTURE REFERENCE ! IMPROPER INSTALLATION, ADJUSTMENT, ALTERATION, SERVICE OR MAINTENANCE CAN CAUSE INJURY OR PROPER

THIS WARRANTY DOES NOT APPLY TO THE FOLLOWING: 1. Breakage of glass components, door glass imperfections, (i.e. glazing, breakage or discolouring. 2

FREQUENTLY ASKED QUESTIONS 1. Front burner is lighting with the red button only. The rear burner isn't starting. (heaters fitted with remote c

FREQUENTLY ASKED QUESTIONS cont’d 5. There is a hissing noise coming from the heater. Is this normal? This is a normal occurrence when the humidifi

NOTES 42

ATTENTION APPLIANCE INSTALLER PLEASE RETURN THESE OPERATING & INSTALLATION INSTRUCTIONS TO THE CONSUMER (FOR FUTURE REFERENCE) DATE OF PURCHASE

4 SAFETY LABELS Air Pressure switch Cut in Pressure Cut out Pressure Electrical Connection Cleveland Controls / RSS-6000-101 65 Pa 50 Pa 2 Mtr flex st

SPECIFICATIONS - MODEL NO. IS700 1 Co-Axial Manifold Flue Starter 65mm 2 Electric Cord 3 1/2” BSP Gas Connection (Inside) 4 3 sided Surround (885

INSTALLATION INSTRUCTIONS GENERAL SAFETY INFORMATION 1. This installation must conform with local codes or, in the absence of local codes, with AG 60

INSTALLATION INSTRUCTIONS CLEARANCE TO COMBUSTIBLES Insert Model IS700 A Rear Wall to Unit 25mm B Side Wall to Unit 15mm C Corner Installation 0mm

INSTALLATION INSTRUCTIONS 1. Rear Log 2. Middle Log 3. Front Log 4. Rear Burner 5. Front Burner NOTE: Do not change position of front, middle and